A pool replastered on assumptions can start failing in places nobody looked at: a hollow patch that was never sounded out, a corroded fitting buried under new plaster, a warranty that excludes the very problem you hired someone to fix. Most of these outcomes trace back to the same cause. The owner called for quotes before knowing what the pool actually looked like, then compared proposals that weren’t describing the same job. Three short lists fix that, and they work in order.
What to Check on Your Own Before Calling Anyone
Do this walk-around in good light, ideally with the pool clear of debris, and take photos as you go. Dated photos give every contractor the same starting point and give you a record to compare against later.
- Run your palm across the floor and walls. Note rough zones, sharp edges, and any spots that feel chalky or sandy.
- Look for stains and discoloration, and note whether they are scattered or concentrated near one fitting, step, or corner.
- Tap gently on suspicious areas with a hard rubber handle. A dull or hollow sound is worth noting and photographing.
- Look for cracks and mark whether they are hairline, open, or following a straight line across the shell.
- Inspect the tile line for loose, cracked, or missing tiles, and for staining or crumbling grout behind them.
- Examine the skimmer lip, return fittings, light niches, and drains for rust streaks, gaps, or movement.
- Record how much water you add and how often. Write the numbers down, even roughly.
This is not a diagnosis. It just means that when someone visits, you can point to specific areas instead of saying the pool feels old.
What a Complete Replastering Quote Should Spell Out
Local options in the area include a company listed as Pool Plastering West Linn, which is reasonable to include in your comparison. Treat it as one contractor to run through the same list as everyone else, not an automatic pick. Whoever you call, the proposal should answer each of these in writing.
- Scope: Does it cover the full shell, the steps and benches, and the tile line? What is explicitly left out?
- Prep and chipping: Will the old surface be removed entirely or only in failed areas? How is the remaining plaster tested for bond, and how is the surface prepared so new material adheres?
- Finish specified: The exact product and color named, not just “standard plaster.”
- Fittings: Who handles worn skimmer lips, returns, and light niches, and is that cost included or separate?
- Warranty: What is covered, for how long, what voids it, and whether the start-up routine is a condition.
- Start-up and fill plan: Who is on site, how fast the fill happens, and what chemistry guidance you receive.
- Hidden damage: What happens when a hollow area or failed fitting appears after draining? Look for a described process, including how the price is set and when you approve it.
The last item separates solid proposals from thin ones. Hidden damage is common in older shells, and a quote that ignores it simply postpones the argument. Also ask about scheduling around the Willamette Valley’s wet stretches, since plastering depends on conditions the crew can’t control. Then set the quotes side by side and mark every line where one proposal is silent.
What to Do From First Fill Through the First Month
The new surface is at its most vulnerable right after the fill. Use this list as your follow-through.
- Keep the fill continuous and confirm the hose stays in place until the water is at the proper level.
- Get the contractor’s start-up instructions in writing, including chemical targets and brushing schedule.
- Keep tools, furniture, and people off the surface until you’ve been told it is safe.
- Test the water on the schedule given and log the results.
- Photograph the surface at the end of the first week and again at the end of the month.
- Report rough spots, early stains, or color variation promptly and in writing, while the warranty clock is clear.
Light mottling and a bit of surface dust are often part of normal curing. Ask the contractor beforehand what counts as normal, so you know when to call and when to wait.
Quick Takeaways
- Inspect and photograph the pool before anyone quotes.
- Compare quotes line by line, especially prep and hidden damage terms.
- Run every local contractor through the same list.
- Follow the start-up instructions closely and document the first month.
